**Updated Gen 3 pricing!!**
Use D-BOX, the most accurate motion system available, on your motion simulator build! Each actuator provides 1.5″ of travel, both motion and vibration from this system. No need for multiple buttkickers or complicated amplifier setups. Engine idle, engine revving, bumps on the track, rumbles strips, and more are acurately reproduced in both motion and vibration. Does not include driving simulator, monitor stand, etc.
D-BOX has provided reliable products to the motion industry for over 10 years. Years of worry free, no maintenance, reliable operation goes without saying (and the warranty to boot). And the Sim Seats integration provides nothing but the best: a strong 1 3/4″ steel tube chassis, powder coated finish, all grade 8 zinc yellow-chromate fasteners and locking nuts to keep the hardware in place. Electronics are mounted under the chassis with wiring solutions to keep all data and power consolidated and clean. Go ahead, run it hard, this system won’t let you down.
Ready To Race
Simply mount the actuators, download the D-BOX software, plug in the USB motion controller, and start racing! The motion platform comes 99% assembled, requiring only the actuators to be bolted to their respective corners. The D-BOX Motion Controller software and Game Center software make installation and setup a breeze. You’ll be moving (literally) in 5 minutes or less (seriously). No special power requirements, no special cables needed. This is the easiest motion system install you’ll find!
Controls At Your Fingertips
The D-BOX Game Center allows for precise adjustment of the motion system. Fore/aft, left/right, heave, engine vibration, and skid vibration can all be fine tuned for iRacing. Make multiple profiles and fine tune each setting depending on the car.
Steel tube construction
Powder coated chassis
Fabric covered floor board
D-BOX 4250i actuators (120v)
D-BOX KAI-1 USB motion controller
Grade 8 zinc yellow-chromate hardware
Bottom mounted control modules
Mounting clamps for SR-X chassis
Ships 99% assembled for quick installation
Carbon fiber corner covers
This motion platform includes D-BOX 4250i actuators (250 lbs max capacity each) mounted to the Sim Seats MP33 motion platform, power cables, aluminum floor cups, mounting hardware, two actuator control modules, and one USB motion controller. Easy to wire up and D-BOX software installation is a breeze, slide this platform under your Sim Seats SR-X driving simulator and you’ll be moving (literally) in no time (seriously).
Fore/aft, left/right, up/down, and vibration are possible with two rear actuators and a two front mounted actuators. This is the most accurate and greatest magnitude actuator kit.
Does not include driving simulator, monitor stand, etc.
D-BOX Software Setup: Install and tuning guide
D-BOX motion platform: Adding to an existing Sim Seat
3″ and 6″ inch systems also available. Please contact us for pricing.